Instrument Function
R&S
®
SMB100A
87Operating Manual 1407.0806.32 ─ 13
On/Off GUI Update
Switchs on/off update of the displayed parameters.
Switching off the update of the displayed parameters increases the speed for certain
settings.
Note: It is especially recommended to switch off the GUI update for optimum sweep
performance with short dwell times and for fast settling times.
Remote command:
:SYSTem:DISPlay:UPDate on page 402
5.2.3.6 NRP-Z Info/Update
The "NRP-Z Info/Update…" dialog covers information on connected power sensors, like
serial number, revision state and features of the particular sensor. You can directly per-
form an update of the sensor firmware.
► To access this dialog, select "Setup > System > NRP-Z Info/Update…".
The "NRP-Z Info / Update" dialog indicates the connected R&S NRP-Z Power Sen-
sors with specific information and contains the functions to update the firmware of a
connected sensor.
The remote commands required to remotely configure the poewr sensor settings are
described in chapter 7.11, "SENSe, READ and INITiate Subsystems", on page 278.
Current Sensors
Shows the sensors that are connected to the generator with information on serial number,
the revision state and some features.
Tip: Click on a sensor to get quick information about the firmware version and whether
this sensor measures the peak of the signal.
Remote command:
SENSe<ch>[:POWer]:TYPE? on page 286
SENSe<ch>[:POWer]:SVERsion? on page 286
SENSe<ch>[:POWer]:SNUMber? on page 285
Update
Section "Update" provides access to the file system in order to select a file for an R&S
NRP sensor update (Button "Select NRP File"), the selected file is indicated to the left of
the button. On the left side, the sensor to be updated is selected.
Button "Run Update" starts the update.
General Instrument Settings
To Next Page
Loading...
