Rohde & Schwarz SMB100A - Generating a Hard Copy of the Display

Instrument Function
R&S
®
SMB100A
103Operating Manual 1407.0806.32 ─ 13
When switching from remote to manual control, the display update suppression function,
if active ("SETUP > GUI Update" is Off), is automatically deactivated ("SETUP > GUI
Update" is On).
5.2.5 Generating a Hard Copy of the Display
The generation of a hardcopy of the display requires that an external keyboard is con-
nected to the instrument. The hardcopy dialog is called with the key combination CTRL
+Z or CTRL+Y depending on the used keyboard settings.
5.2.5.1 Hardcopy Dialog
Destination
Indicates that the hardcopy is stored in a file (see also "File Options" on page 104).
Remote command:
:HCOPy:DEVice on page 259
Options
Opens the Hardcopy Options dialog for configuring the hardcopy parameters (see "File
Options" on page 104.
Remote command:
n.a.
File
Some configuration parameters are already offered in the Hardcopy dialog. All configu-
ration parameters are available in "File Options" on page 104.
Automatic Naming
Activates, deactivates automatic generation of the file name. Automatic naming is con-
figured in the "Options…" submenu, see "File Options" on page 104.
Remote command:
:HCOPy:FILE[:NAME]:AUTO:STATe on page 264
General Instrument Settings