Preparing for Use
R&S
®
SMB100A
21Operating Manual 1407.0806.32 ─ 13
RF 50 Ohm
Output for RF signal.
Depending on the equipped frequency option, the RF output connectors vary.
RF Option
Microwave Option
Frequency options Connector
type
Frequency options Connector
type
R&S SMB- B101
N female
R&S SMB-B112/-112L
PC 3.5 mm
R&S SMB-B102 R&S SMB-B120/-B120L
R&S SMB-B103 R&S SMB-B140/-140L PC 2.92 mm
R&S SMB-B106
NOTICE! Maximum Input Levels. Do not overload the RF output. The maximum permis-
sible back-feed is specified in the data sheet.
2.2 Rear Panel Tour
This section gives an overview of connectors on the rear panel of the instrument. Each
connector is briefly described and a reference is given to the chapters containing detailed
information. For technical data of the connectors refer to the data sheet.
Fig. 2-2: Rear panel view
Rear Panel Tour
To Next Page
Loading...
