Rohde & Schwarz SMB100A - Software; Options

Instrument Function
R&S
®
SMB100A
84Operating Manual 1407.0806.32 ─ 13
Power On Count
Displays the number of power-on.
Remote command:
:DIAGnostic:INFO:POCount? on page 253
Assembly
The tables list the installed assemblies.
"Assembly"
Assembly name
"Part Number"
Part Number of assembly
"Revision"
Revision state of assembly
Remote command:
:DIAGnostic<hw>:BGINfo? on page 252
5.2.3.3 Software / Options
The "Software/Options" dialog shows the firmware version of the instrument software as
well as all installed hardware and software options.
Software options purchased at a later stage can be activated with a keycode. The acti-
vation code is supplied with the software option. How to install options is described in
Chapter 4 of the Service Manual (supplied with the instrument).
The installation of hardware options purchased at a later stage is also described in Chap-
ter 4 of the Service Manual (supplied with the instrument). Most hardware options need
to be installed at an authorized Rohde&Schwarz service shop.
To access the "Software/Options" dialog, select "System" and press the SETUP or
MENU key.
The menu is devided into the following sections:
●
"Firmware"
●
"Hardware Options"
●
"Software Options"
General Instrument Settings