Rohde & Schwarz SMB100A - H Copy: F ILE[: N AME]: a UTO[: F ILE]: P Refix; Hcopy:file[:Name]:Auto[:File]:Number

Remote Control Commands
R&S
®
SMB100A
263Operating Manual 1407.0806.32 ─ 13
Parameters:
<State> 0 | 1 | OFF | ON
*RST: ON
Example:
HCOP:FILE:AUTO:MONT:STAT OFF
deactivates the usage of the month in the automatic file name.
Manual operation: See "File Options" on page 104
:HCOPy:FILE[:NAME]:AUTO[:FILE]:NUMBer?
This command queries the number in the automatic file name. The number is assigned
in such a way that always the lowest possible value for an unique file name within the
selected path is used.
On initially switching on the device the number will be reset to the lowest possible value.
Starting with number 0 the output directory will be scanned for already existing files. As
long as files with the same name are existing the number will be incremented by 1. The
number will be automatically set to a number so that the resulting file name will be unique
within the selected path. The current number will not be saved in the save recall file but
will be temporarily stored within the database. On subsequent saves the number will be
incremented.
Return values:
<Number> integer
Range: 0 to 999999
*RST: 0
Example:
HCOP:FILE:AUTO:NUMB?
queries the number in the automatic file name.
Usage: Query only
Manual operation: See "File Options" on page 104
:HCOPy:FILE[:NAME]:AUTO[:FILE]:PREFix <Prefix>
This command defines the prefix part in the automatic file name. The usage of the prefix
is activated with command HCOP:FILE:AUTO:PREF:STAT ON.
Parameters:
<Prefix> string
*RST: HCopy
Example:
HCOP:FILE:AUTO:PREF 'Snapshot'
appends "Snapshot" as prefix to the generated file name.
Manual operation: See "File Options" on page 104
:HCOPy:FILE[:NAME]:AUTO[:FILE]:PREFix:STATe <State>
This command activates the usage of the prefix in the automatic file name. The prefix is
entered with command HCOP:FILE:AUTO:PREF.
HCOPy Subsystem