Rohde & Schwarz SMB100A - Display; Keys for Setting Paramters; Setup Keys

Preparing for Use
R&S
®
SMB100A
17Operating Manual 1407.0806.32 ─ 13
2.1.3 Display
The display clearly shows all main settings and signal generator states.
The display is divided into the following sections:
●
Frequency and level display with info line
– Frequency and level settings containing offset.
– Status messages
– Brief error messages.
To access an window with detailed information for a message, use the INFO key.
●
Block diagram
The block diagram shows the current configuration and the signal flow in the gener-
ator with the aid of function blocks containing an on/off switch. Selecting a function
block opens a list of associated setting menus. Active menus, info windows and
graphs are displayed on top of the block diagram. The block diagram can be displayed
in the foreground anytime with the DIAGRAM key.
For detailed information, see chapter 4.2, "Display", on page 56.
2.1.4 Setup Keys
The keys to the right of the display set parameters, select views and control the windows.
2.1.4.1 Keys for Setting Paramters
These keys provide direct access to the settings in the header of the instrument for fast
setting the RF signal.
For more information refer to chapter "Instrument Functions".
FREQ
Activates frequency entry.
LEVEL
Activates level entry.
ON/OFF TOGGLE
●
Switches highlighted elements or a function block on and off.
●
Switches between two or more settings, e.g. items of selection lists. At the end of a
list, the cursor is set on the first entry again.
BACKSPACE
Deletes the character to the left of the cursor.
Front Panel Tour