Rohde & Schwarz SMB100A - [: S Ource<Hw>]: L IST: S Elect; [: S Ource<Hw>]: L IST: T Rigger: S Ource; [:Source<Hw>]:List:running; [:Source<Hw>]:List:trigger:execute

Remote Control Commands
R&S
®
SMB100A
332Operating Manual 1407.0806.32 ─ 13
Usage: Event
Manual operation: See "Reset - List Mode" on page 162
[:SOURce<hw>]:LIST:RUNNing?
Queries the current state of the list mode.
Return values:
<State> 0 | 1 | OFF | ON
Example:
LIST:RUNN?
Response "1": signal generation based on the list mode is being
performed.
Usage: Query only
[:SOURce<hw>]:LIST:SELect <Filename>
The command selects the specified list. If a new list is to be created, the name can be
entered here. The list is created if it does not yet exist. The list selected here is available
for the further processing steps (editing) and is used in the instrument when the List mode
is activated.
The files are stored with the fixed file extensions *.lsw in a directory of the user's choice.
The directory applicable to the command is defined with the command MMEMory:CDIR.
A path can also be specified in command :SOUR:LIST:SEL in which case the list mode
file in the specified directory is selected.
*RST does not affect data lists.
Parameters:
<Filename> '<list name>'
Example:
LIST:SEL '/var/user//Lists/Listmode/list3'
selects list3 for editing. List3 is created if it does not yet exist.
Manual operation: See "List Mode Data... - List Mode" on page 163
[:SOURce<hw>]:LIST:TRIGger:EXECute
The command immediately starts the processing of a list in list mode. It corresponds to
the manual-control command "Execute Single."
Example:
SOUR:LIST:TRIG:EXEC
triggers the processing of the selected list.
Usage: Event
Manual operation: See "Execute Single - List Mode" on page 162
[:SOURce<hw>]:LIST:TRIGger:SOURce <Source>
The command sets the trigger source for the LIST mode.
SOURce Subsystem