Instrument Function
R&S
®
SMB100A
114Operating Manual 1407.0806.32 ─ 13
The dialog displays the /var/user/share testftp file.
5.3 RF Block
5.3.1 Overview of RF Signal
Settings for the RF output signal and analog modulation are made under "RF Signal".
These settings can be accessed in the block diagram by way of the "RF" function block,
or by means of the menu with the same name which is opened using the MENU key.
The function block is available for the basic unit (R&S SMB + frequency option R&S SMB-
B10x) without additional equipment options.
5.3.1.1 RF Output
To activate and deactivate the RF output signal, use one of the following alternatives:
●
by means of the RF ON/OFF key (the current entry focus is irrelevant)
● by changing the state of the "RF" functional block (see "State RF" on page 115)
● by enabling/disabling the RF in the "Configure" menu of the "RF" block (see "RF
Output State" on page 115).
The current state of the RF output (activated and deactivated) is indicated in the block
diagram by means of the different block color and the status of the "On" checkbox.
An active sweep is also indicated in the block.
RF Block
To Next Page
Loading...
