Rohde & Schwarz SMB100A - Source:stereo Subsystem

Remote Control Commands
R&S
®
SMB100A
368Operating Manual 1407.0806.32 ─ 13
Example:
ROSC:SOUR EXT
selects the external source.
ROSC:EXT:FREQ 5 MHz
informs the instrument that the external reference has a frequency
of 5 MHz.
Manual operation: See "Source - Reference Oscillator" on page 120
7.12.15 SOURce:STEReo Subsystem
This subsystem contains the SCPI commands for generating FM stereo multiplex signals,
the radio traffic service ARI (Automotive Radio Information) and Radio Data System
(RDS). Additional functions are available using the SOURce:STEReo:DIRect com-
mands (see chapter 7.18, "Direct Commands for the Stereo/RDS Coder Option R&S
SMB-B5", on page 412).
[:SOURce]:STEReo:ARI:BK[:CODE]................................................................................368
[:SOURce]:STEReo:ARI:STATe......................................................................................369
[:SOURce]:STEReo:ARI:TYPE........................................................................................369
[:SOURce]:STEReo:ARI:TYPE:STATe.............................................................................370
[:SOURce]:STEReo:ARI[:DEViation]................................................................................370
[:SOURce]:STEReo:AUDio:MODE...................................................................................370
[:SOURce]:STEReo:AUDio:PREemphasis........................................................................371
[:SOURce]:STEReo:AUDio:PREemphasis:STATe.............................................................372
[:SOURce]:STEReo:AUDio[:FREQuency].........................................................................372
[:SOURce]:STEReo:DIRect.............................................................................................372
[:SOURce]:STEReo:EXTernal:IMPedance........................................................................373
[:SOURce]:STEReo:MMF...............................................................................................373
[:SOURce]:STEReo:PILot:PHASe....................................................................................373
[:SOURce]:STEReo:PILot:STATe....................................................................................374
[:SOURce]:STEReo:PILot[:DEViation]..............................................................................374
[:SOURce]:STEReo:RDS:DATaset..................................................................................374
[:SOURce]:STEReo:RDS:STATe.....................................................................................375
[:SOURce]:STEReo:RDS:TRAFfic:ANNouncement[:STATe]...............................................375
[:SOURce]:STEReo:RDS:TRAFfic:PROGram[:STATe]......................................................375
[:SOURce]:STEReo:RDS[:DEViation]...............................................................................376
[:SOURce]:STEReo:SOURce..........................................................................................376
[:SOURce]:STEReo:STATe.............................................................................................376
[:SOURce]:STEReo[:DEViation].......................................................................................377
[:SOURce]:STEReo:ARI:BK[:CODE] <Code>
Selects the area identification (BK) code of the ARI signal. The six letters (six different
frequencies) identify a specific region in each country. The code is generated if the BK
or DK+BK identifier of the ARI signal is activated.
Parameters:
<Code> A | B | C | D | E | F
*RST: A
SOURce Subsystem