Remote Control Commands
R&S
®
SMB100A
274Operating Manual 1407.0806.32 ─ 13
Usage: Setting only
SCPI confirmed
Manual operation: See "Rename " on page 112
:MMEMory:MSIS <Msis>
The command is without effect for the Linux operating system.
Usage: SCPI confirmed
:MMEMory:RDIRectory <Rdirectory>
Removes an existing directory from the mass memory storage system. If no directory is
specified, the subdirectory with the specified name is deleted in the default directory.
Setting parameters:
<Rdirectory> string
String parameter to specify the directory to be deleted.
Example:
See "Working with Files and Directories" on page 268.
Usage: Setting only
:MMEMory:STORe:STATe <savrcl_state_nr>, <file_name>
Stores the current instrument setting in the specified file.
The instrument setting must first be stored in an internal memory with the same number
using the common command *SAV.
Setting parameters:
<savrcl_state_nr> Corresponds to the specific <number> defined with the *SAV
command, e.g. *SAV 4.
<file_name> String parameter to specify the file name with extension
*.savrcltxt.
Example:
See "Storing and Loading Current Settings" on page 268.
Usage: Event
Manual operation: See "Save" on page 109
7.10 OUTPut Subsystem
The OUTPut system contains the commands which set the properties of the RF output
connector.
The properties of the LF output connector are set in the chapter 7.12.6, "SOURce:LFOut-
put Subsystem", on page 310 system.
OUTPut Subsystem
To Next Page
Loading...
