Rohde & Schwarz SMB100A - Status Subsystem

Remote Control Commands
R&S
®
SMB100A
388Operating Manual 1407.0806.32 ─ 13
Example:
SWE:RES
resets all active sweeps to the starting point.
Usage: Event
Manual operation: See "Reset Sweep - Frequency Sweep" on page 151
7.13 STATus Subsystem
This system contains the commands for the status reporting system. See also chap-
ter 6.5, "Status Reporting System", on page 233 for detailed information.
*RST on page 246 has no effect on the status registers.
Value ranges
●
Queries return the current value of the respective register, which permits a check of
the device status.
Return values: A decimal value in the range 0 to 32767 (=2
15
-1)
●
The configuration commands set the respective register thus determining which sta-
tus changes of the R&S SMB cause the status registers to be changed.
Setting values: A decimal value in the range 0 to 32767 (=2
15
-1)
:STATus:OPERation:CONDition......................................................................................388
:STATus:OPERation:ENABle..........................................................................................389
:STATus:OPERation[:EVENt]..........................................................................................389
:STATus:OPERation:NTRansition....................................................................................389
:STATus:OPERation:PTRansition....................................................................................389
:STATus:PRESet...........................................................................................................390
:STATus:QUEStionable:CONDition..................................................................................390
:STATus:QUEStionable:ENABle......................................................................................390
:STATus:QUEStionable[:EVENt]......................................................................................390
:STATus:QUEStionable:NTRansition................................................................................391
:STATus:QUEStionable:PTRansition................................................................................391
STATus:QUEue[:NEXT]?................................................................................................391
:STATus:OPERation:CONDition <Condition>
Sets the content of the CONDition part of the STATus:OPERation register. This part
contains information on the action currently being performed in the instrument. The con-
tent is not deleted after being read out because it indicates the current hardware status.
Parameters:
<Condition> string
Example:
:STATus:OPERation:CONDition?
queries the Status:Operation:Condition register.
STATus Subsystem