Rohde & Schwarz SMB100A - Page 405

Remote Control Commands
R&S
®
SMB100A
389Operating Manual 1407.0806.32 ─ 13
:STATus:OPERation:ENABle <Enable>
Sets the bits of the ENABle part of the STATus:OPERation register. This setting deter-
mines which events of the Status-Event part are forwarded to the sum bit in the status
byte. These events can be used for a service request.
Parameters:
<Enable> string
Example:
:STAT:OPER:ENAB 32767
all events are forwarded to the sum bit of the status byte.
:STATus:OPERation[:EVENt] <Event>
Queries the content of the EVENt part of the STATus:OPERation register. This part con-
tains information on the actions performed in the instrument since the last readout. The
content of the EVENt part is deleted after being read out.
Parameters:
<Event> string
Example:
:STAT:OPER:EVEN?
queries the STATus:OPERation:EVENt register.
:STATus:OPERation:NTRansition <Ntransition>
Sets the bits of the NTRansition part of the STATus:OPERation register. If a bit is set, a
transition from 1 to 0 in the condition part causes an entry to be made in the EVENt part
of the register. The disappearance of an event in the hardware is thus registered, for
example the end of an adjustment.
Parameters:
<Ntransition> string
Example:
:STAT:OPER:NTR 0
a transition from 1 to 0 in the condition part of the Status:Operation
register does not cause an entry to be made in the EVENt part.
:STATus:OPERation:PTRansition <Ptransition>
Sets the bits of the PTRansition part of the STATus:OPERation register. If a bit is set, a
transition from 0 to 1 in the condition part causes an entry to be made in the EVENt part
of the register. A new event in the hardware is thus registered, for example the start of
an adjustment.
Parameters:
<Ptransition> string
Example:
:STAT:OPER:PTR 32767
all transitions from 0 to 1 in the condition part of the Status:Oper-
ation register cause an entry to be made in the EVENt part.
STATus Subsystem