Preparing for Use
R&S
®
SMB100A
24Operating Manual 1407.0806.32 ─ 13
The OCXO generates a very precise 10 MHz reference signal. It needs some minutes of
warm-up time to reach its nominal frequency.
Refer also to the data sheet for detailed information.
2.3 Putting into Operation
This section describes the basic steps to be taken when setting up the R&S SMB for the
first time.
Risk of injury and instrument damage
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing.
●
Read and observe the "Basic Safety Instructions" at the beginning of this manual or
on the documentation CD-ROM, in addition to the safety instructions in the following
sections. Notice that the data sheet may specify additional operating conditions.
Risk of instrument damage
Note that the general safety instructions also contain information on operating conditions
that will prevent damage to the instrument. The instrument's data sheet may contain
additional operating conditions.
Putting into Operation
To Next Page
Loading...
