Rohde & Schwarz SMB100A - Display Subsystem

Remote Control Commands
R&S
®
SMB100A
254Operating Manual 1407.0806.32 ─ 13
Example:
DIAG:INFO:POC
queries the number of power on events.
Response: 123
The instrument was switched on for 123 times up to now.
Usage: Query only
Manual operation: See "Power On Count" on page 84
7.5 DISPlay Subsystem
The DISPlay subsystem contains the commands to set the power-save mode of the
instrument.
:DISPlay:ANNotation:AMPLitude.....................................................................................254
:DISPlay:ANNotation:FREQuency....................................................................................254
:DISPlay:ANNotation[:ALL]..............................................................................................255
:DISPlay:DIALog:CLOSe................................................................................................255
:DISPlay:DIALog:ID?......................................................................................................255
:DISPlay:DIALog:OPEN..................................................................................................255
:DISPlay:PSAVe:HOLDoff...............................................................................................256
:DISPlay:PSAVe[:STATe]................................................................................................256
:DISPlay:UPDate...........................................................................................................256
:DISPlay:ANNotation:AMPLitude <State>
Fades out level display in the header of the instrument and displays asterisks instead.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:ANN:AMPL ON
shows asterisks instead of level values.
Manual operation: See "Annotation Amplitude" on page 100
:DISPlay:ANNotation:FREQuency <State>
Fades out frequency display in the header of the instrument and displays asterisks
instead.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:ANN:FREQ ON
shows asterisks instead of the frequency.
Manual operation: See "Annotation Frequency" on page 100
DISPlay Subsystem