Rohde & Schwarz SMB100A - Display;Keyboard Settings

Instrument Function
R&S
®
SMB100A
92Operating Manual 1407.0806.32 ─ 13
IP Address
Displays the IP address. To enter the IP address manually, select "Static" Address Mode.
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress on page 398
Subnet Mask
Displays the Subnet mask. To enter the Subnet mask manually, select "Static" Address
Mode.
This number is used together with the IP address to identify the network segment the
instrument is in.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK on page 399
Default Gateway
Displays the IP address of the default gateway. To enter the default gateway manually,
select "Static" Address Mode.
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway on page 398
Restart Network
Shuts down the network connection of the instrument and subsequently re-establishes
the connection.
This function can be used to resolve network problems.
Note: Only the connection of the instrument to the network restarts, the network itself is
not affected.
Remote command:
n.a.
5.2.3.12 Display/Keyboard Settings
In the "Display/Keyboard Settings" menu the power-save mode and external keyboard
settings are made. It is opened using the SETUP or MENU key under "Environment".
Screen Saver Active
Activates/deactivates the screen-save mode of the display.
General Instrument Settings