Instrument Function
R&S
®
SMB100A
91Operating Manual 1407.0806.32 ─ 13
The dialog provides an access to the network settings, like settings about the general
network environment and specific identification of the computer in the network, as well
as an indication whether the instrument is connected to the network or not.
Network Status
Indicates whether the instrument is connected to the network or not.
Remote command:
n.a.
Hostname
Enters the individual computer name of the R&S Signal Generator.
Note: The computer name can only be changed after protection level 1 is deactivated
(see chapter 5.2.3.14, "Protection", on page 96).
A predefined name is indicated and can be used for network connections.
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname on page 397
Workgroup
Enters the individual windows workgroup name of the R&S Signal Generator. This
parameter is necessary in case the instrument is integrated in a windows network.
Note: The workgroup can only be changed after protection level 1 is deactivated (see
chapter 5.2.3.14, "Protection", on page 96).
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup on page 397
Address Mode
Selects if the IP address is assigned automatically or manually.
"Auto (DHCP)"
The IP address is assigned automatically.
The network used must support automatic assignment of IP address
via DHCP or APIPA (Zeroconf) in order to use this function.
"Static"
The IP address is assigned manually.
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress:MODE on page 398
General Instrument Settings
To Next Page
Loading...
