Rohde & Schwarz SMB100A - [: S Ource<Hw>]: S Weep[: F Requency]: S Hape; [: S Ource<Hw>]: S Weep[: F Requency]: S Pacing; [:Source<Hw>]:Sweep[:Frequency]:Running

Remote Control Commands
R&S
®
SMB100A
382Operating Manual 1407.0806.32 ─ 13
[:SOURce<hw>]:SWEep[:FREQuency]:RUNNing?
Queries the current state of the frequency sweep mode.
Return values:
<State> 0 | 1 | OFF | ON
Example:
SWE:RUNN?
Response "1": signal generation in level sweep active.
Usage: Query only
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe <Shape>
The command sets the cycle mode for a sweep sequence (shape).
Parameters:
<Shape> SAWTooth | TRIangle
SAWTooth
One sweep runs from start to stop frequency. Each subsequent
sweep starts at the start frequency, i.e. the shape of the sweep
sequence resembles a sawtooth.
TRIangle
One sweep runs from start to stop frequency and back, i.e. the
shape of the sweep resembles a triangle. Each subsequent sweep
starts at the start frequency.
*RST: SAWTooth
Example:
SOUR:SWE:SHAP TRI
selects the sweep cycle with alternating ascending and descend-
ing sweep directions.
Manual operation: See "Shape - RF Frequency Sweep" on page 152
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing <Spacing>
The command selects the sweep spacing.
The keyword [:FREQuency] can be omitted (see example). The command is then
SCPI-compliant.
SOURce Subsystem