Rohde & Schwarz SMB100A - Settings Displayed in the Header Section; Display

Manual Operation
R&S
®
SMB100A
56Operating Manual 1407.0806.32 ─ 13
required. All messages are explained in the online help which can be called with the
HELP (F1) key.
4.2 Display
The display shows the current signal generator state and offers graphical elements for
direct operation. It is divided into three sections:
●
The frequency and level display with info line indicates the main output signal param-
eters and reports the current state with status, error and warning messages.
●
The block diagram shows the instrument configuration, the signal characteristic as
well as the inputs and outputs used and permits interactive operation via graphics
elements. Active menus and graphs are displayed on top of the block diagram.
●
Winbar with labelled softkeys for menu display.
The block diagram in the figure below shows a fully equipped instrument.
Fig. 4-1: Block diagram of a fully equipped R&S Signal Generator
4.2.1 Settings Displayed in the Header Section
Frequency/level settings and a few status messages (see chapter 4.2.2, "Status Infor-
mation and Messages", on page 57) are displayed in the header field of the screen.
The display may vary depending on the instrument's operating mode:
●
In the sweep mode, the current frequency or level of the output signal is displayed.
The status message "SweepMode" is displayed in the info line.
●
In the list mode, neither the current frequency nor level is displayed, the indication is
dimmed.
●
If user correction is active, the status message "UCorr" is displayed in the info line.
Display