Rohde & Schwarz SMB100A - S Ystem: C Ommunicate: N Etwork: I Paddress; S Ystem: C Ommunicate: N Etwork: I Paddress: M ODE; S Ystem: C Ommunicate: N Etwork[: I Paddress]: G Ateway

Remote Control Commands
R&S
®
SMB100A
398Operating Manual 1407.0806.32 ─ 13
Manual operation: See "Workgroup" on page 91
:SYSTem:COMMunicate:NETWork:IPADdress:MODE <Mode>
Selects if the IP address is assigned automatically or manually. The entry is activated
only after sending command SYST:COMM:NETW:IPAD:SET.
Parameters:
<Mode> AUTO | STATic
*RST: AUTO
Example:
SYST:COMM:NETW:IPAD:MODE AUTO
the IP address is assigned automatically (DHCP).
SYST:COMM:NETW:IPAD:SET ON
activates DHCP.
Manual operation: See "Address Mode" on page 91
:SYSTem:COMMunicate:NETWork:IPADdress <IpAddress>
Sets the IP address. The entry is only activated after sending command
SYST:COMM:NETW:IPAD:SET.
Parameters:
<IpAddress> string
Range: 0.0.0.0. to ff.ff.ff.ff
Example:
SYST:COMM:NETW:IPAD 7.8.9.10
sets the IP address of the instrument.
Example:
SYST:COMM:NETW:IPAD:SET
activates all changes of the IP address settings.
Manual operation: See "IP Address" on page 92
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway <Gateway>
Sets the IP address of the default gateway. The entry is activated only after sending
command SYST:COMM:NETW:IPAD:SET.
Parameters:
<Gateway> string
Range: 0.0.0.0 to ff.ff.ff.ff
Example:
SYST:COMM:NETW:GAT 1.2.3.4
sets the IP address of the default gateway.
SYST:COMM:NETW:IPAD:SET
activates all changes of the IP address settings.
Manual operation: See "Default Gateway" on page 92
SYSTem Subsystem