Rohde & Schwarz SMB100A - [: S Ource<Hw>]: P ULM: T Rain: O Fftime; [:Source<Hw>]:Pulm:train:offtime:points

Remote Control Commands
R&S
®
SMB100A
355Operating Manual 1407.0806.32 ─ 13
The files are stored with the fixed file extensions *.pulstrn in a directory of the user's
choice. The directory applicable to the command is defined with the command
MMEMory:CDIR. To access the files in this directory, only the file name has to be given
without the path and the file extension.
Setting parameters:
<Filename> <list file name>
Example:
MMEM:CDIR '/var/user/lists/pulsetrain'
selects the directory for the pulse train files.
PULM:TRA:DEL 'P_FIVE'
deletes the list P_FIVE
Usage: Setting only
Options: R&S SMB-K27 (Pulse Train)
Manual operation: See "Pulse Train Data – Pulse Generator" on page 198
[:
SOURce<hw>]:PULM:TRAin:OFFTime <OffTime>
Fills the Offtime part of the selected file with data.
*RST does not affect data lists.
Parameters:
<OffTime> Offtime#1{, Offtime#2, ...} | binary block data
The data can be given either as a list of numbers (list can be of
any length and list entries must be separated by commas) or as
binary block data.
When block data is transferred, 8 (4) bytes are always interpreted
as a floating-point number with double accuracy (see the com-
mand FORMat:DATA).
The maximum length is 2047 values.
Range: 0 ns to 5 ms
Example:
MMEM:CDIR '/var/user/lists/pulsetrain'
selects the directory for the pulse train files.
PULM:TRA:SEL ‘P_INCR'
selects P_INCR for editing. P_INCR is created if it does not yet
exist.
PULM:TRA:OFFT 10ns,15ns,40ns,...
specifies the offtime values in P_INCR. If the list already contains
data, it is overwritten.
Options: R&S SMB-K27 (Pulse Train)
Manual operation: See "Edit Pulse Train Data" on page 198
[:SOURce<hw>]:PULM:TRAin:OFFTime:POINts?
Queries the length (in points) of the offtime component of the selected list.
SOURce Subsystem