Instrument Function
R&S
®
SMB100A
141Operating Manual 1407.0806.32 ─ 13
Fill User Correction Data with Sensor Settings
The "Fill with Sensor" button of the "Edit User Correction Data" menu opens the associ-
ated menu.
The menu indicates the relevant generator settings.
Fill User Correction Data with Sensor
All settings are read-only, except the "Sensor". In case more than one sensor is connec-
ted to the instrument, the sensor can be selected in the "Sensor" field of menu.
The "Execute" button is only enabled if a sensor is detected and the user correction list
contains at least one frequency value.
Remote command:
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
on page 294
5.3.6 RF Measurement
5.3.6.1 NRP-Z Power Viewer
The R&S signal generator supports R&S NRP-Z power sensors to measure the power
of the output signal in the RF path or any freely selectable source. The generator performs
up to four power measurements, with the sensors either directly connected, or via the
R&S NRP-Z5 USB Sensor Hub.
The R&S NRP-Z5 USB Sensor Hub (high-speed USB 2.0) can host up to 4 R&S NRP-Z
sensors and provides simultaneous internal and external triggering of all connected sen-
sors.
You can directly connect the R&S NRP-Z Sensors to the standard NRP sensor connec-
tors of the hub. The hub is connected to the R&S instrument via USB with the adapter
cable R&S NRP-Z4.
See also the R&S website http://www.rohde-schwarz.com in section "Power Meters &
Voltmeters > R&S NRP-Z Sensors" for information on the sensor hub and the available
accessories.
To connect a sensor directly at a USB interface, the USB adapters R&S NRP-Z3 or R&S
NRP-Z4 are available.
RF Block
To Next Page
Loading...
