Rohde & Schwarz SMB100A - Examples

Remote Control Commands
R&S
®
SMB100A
433Operating Manual 1407.0806.32 ─ 13
Example:
STEReo:DIRect "TRANS1=0123456789ABCDEF"
The data "0123456789ABCDEF" is sent instead of the RDS data.
Example:
STEReo:DIRect? "TRANS1"
Reads the transparent data.
Response: "0123456789ABCDEF"
7.18.2 Examples
7.18.2.1 Alternative Frequency Lists
Alternative frequency lists can be transmitted in two ways:
●
Method A:
The frequencies of an AF list are entered one after the other; the frequency currently
transmitted has to be specified as the first frequency.
●
Method B:
The frequencies of an AF list are entered in pairs, each pair containing the frequency
currently transmitted and an alternative frequency. The frequency pairs should nor-
mally be entered in ascending order. Descending order should be chosen only if the
alternative frequencies belong to different regions or are used to broadcast different
programs at different times.
Do not combine methods A and B!
Method A:
1. Generate a new alternative frequency list with
STEReo:DIRect "AF=N,87.6,87.7,87.8".
2. Set the group sequence, e.g.
STEReo:DIRect "GS=0A,14A".
The group sequence must contain group 0A.
The alternative frequencies are now transmitted in group 0A.
3. Add another alternative frequency list with
STEReo:DIRect "AF=+,88.6,88.7,88.8"
Method B:
1. Generate a new alternative frequency list with
STEReo:DIRect "AF=N,87.6,90.2,87.6,90.2".
2. Set the group sequence, e.g.
STEReo:DIRect "GS=0A,14A".
The group sequence must contain group 0A
The alternative frequencies are now transmitted in group 0A.
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5