Rohde & Schwarz SMB100A - S Ystem: I Dentification; S Ystem: L Anguage

Remote Control Commands
R&S
®
SMB100A
401Operating Manual 1407.0806.32 ─ 13
Example:
SYST:COMM:SOCK:RES?
Usage: Query only
Manual operation: See "Visa Resource Strings" on page 96
:SYSTem:IDENtification <Identification>
Selects the mode the instrument identification is performed.
Parameters:
<Identification> AUTO | USER
AUTO
The "IDN String" and the "OPT String" are set automatically.
USER
Enables the selection of user definable "IDN String" and "OPT
String".
*RST: AUTO
Example:
SYST:IDEN USER
selects the user defined identification string.
Manual operation: See "Identification Mode" on page 95
:SYSTem:LANGuage <Language>
Sets the remote control command set.
The instrument can also be remote controlled via the command set of several other gen-
erators, e.g. HP generator.
Please check for the corresponding Application Note at the download area of the product
site on the Internet. The Application Note is also provided on the user documentation CD-
ROM (included in delivery).
Note: While working in a emulation mode, the instrument's specific command set is dis-
abled, i.e. the SCPI command SYST:LANG will be discarded.
The return to the SCPI command set of the R&S SMB can only be performed by using
the appropriate command of the selected command set. For example, the HP command
EX returns to the instrument-specific GPIB command set (selection SYST:LANG
HPxxxx).
Parameters:
<Language> string
Example:
SYST:LANG?
Response: SCPI
The SCPI command set is used.
Manual operation: See "Language" on page 94
SYSTem Subsystem