Rohde & Schwarz SMB100A - [: S Ource<Hw>]: C Orrection: D Exchange: M ODE; [:Source<Hw>]:Correction:dexchange:execute

Remote Control Commands
R&S
®
SMB100A
297Operating Manual 1407.0806.32 ─ 13
Parameters:
<Decimal> DOT | COMMa
*RST: DOT
Example:
CORR:DEXC:MODE EXP
selects that the user correction list is exported into an ASCII file.
CORR:DEXC:AFIL:SEL '/var/user/import ucor.csv'
selects ASCII file ucor.csv as destination for the user correction
list data.
CORR:DEXC:AFIL:SEP:COL TAB
the pairs of frequency and level values are separated by a tabu-
lator.
CORR:DEXC:AFIL:SEP:DEC DOT
selects the decimal separator dot.
CORR:DEXC:SEL '/var/user/import ucor_imp'
selects that the user correction list ucor_imp is imported into ASCII
file ucor.csv.
Manual operation:
See "Decimal Point - User Correction" on page 138
[:SOURce<hw>]:CORRection:DEXChange:EXECute
The command starts the export or import of the selected file. When import is selected,
the ASCII file is imported as user correction list. When export is selected, the user cor-
rection list is exported into the selected ASCII file.
Example:
CORR:DEXC:MODE IMP
selects that ASCII files with frequency and level value pairs are
imported and transferred into user correction lists.
CORR:DEXC:AFIL:SEL '/var/user/import ucor.csv'
selects that ASCII file ucor.csv is imported.
CORR:DEXC:SEL '/var/user/import ucor_imp'
selects that the ASCII file ucor.csv is imported into user correction
list ucor_imp.
CORR:DEXC:EXEC
starts the import of the ASCII file data into the user correction file.
Usage: Event
Manual operation: See "Import / Export - User Correction" on page 139
[:SOURce<hw>]:CORRection:DEXChange:MODE <Mode>
The command selects if user correction lists should be imported or exported. Depending
on the selection her, the file select command define either the source or the destination
for user correction lists and ASCII files.
Parameters:
<Mode> IMPort | EXPort
*RST: IMPort
SOURce Subsystem