Getting Started
R&S
®
SMB100A
46Operating Manual 1407.0806.32 ─ 13
Remote Access
Remote access is the operating of the instrument from a remote computer. Both the R&S
SMB and the computer are connected in a LAN.
Remote access in contrast to remote control does not use remote-control commands
but a separate software which is installed on the remote computer. After its start, the
software simulates the user interface of the instrument. The instrument can thus be oper-
ated from the remote computer as on the unit itself. The individual functions are operated
using the mouse and keyboard. Specific instrument functions can be executed using
specific key combinations on the keyboard or a front panel key emulation that can be
operated with the mouse.
This way of operation and the instructions how to set up a connection for remote access
are described in chapter 2.7, "Remote Access via an External Controller", on page 37.
3.2 Application Field of the Instrument
The main field of application of the R&S SMB is the generation of sine wave signals with
very high spectral purity. These signals are needed e.g. for adjacent channel or phase
noise measurements. In addition, the RF signal can be modulated with the internal mod-
ulations waveforms sine waves and rectangular signals.
3.3 Description of Individual Diagram Blocks
The signal path of the instrument is configured by installing a frequency option that com-
prises all required modules.
Application Field of the Instrument
To Next Page
Loading...
