Remote Control Commands
R&S
®
SMB100A
406Operating Manual 1407.0806.32 ─ 13
Table 7-2: Cross-reference between the manual and remote control
R&S name SCPI name Command under manual control
AUTO IMMediate "Auto" mode
SINGle BUS "Single" mode.
EXTernal EXTernal "Ext Single" and "Ext Step" mode.
Use command LFO:SWEep:MODE
to select between the two sweep
modes.
EAUTo - "Ext Start/Stop" mode.
:TRIGger<hw>:FSWeep:SOURce....................................................................................406
:TRIGger<hw>:FSWeep[:IMMediate]................................................................................407
:TRIGger<hw>:LFFSweep..............................................................................................407
:TRIGger<hw>:LFFSweep:SOURce.................................................................................408
:TRIGger<hw>:LFFSweep:IMMediate..............................................................................408
:TRIGger<hw>:PSWeep:SOURce....................................................................................409
:TRIGger<hw>:PSWeep[:IMMediate]................................................................................409
:TRIGger<hw>[:SWEep]:SOURce....................................................................................410
:TRIGger<hw>[:SWEep][:IMMediate]................................................................................411
:TRIGger<hw>[:IMMediate].............................................................................................411
:TRIGger<hw>:FSWeep:SOURce <Source>
The command sets the trigger source for the RF frequency sweep.
The names of the parameters correspond directly to the various settings under manual
control. SCPI uses other names for the parameters; these names are also accepted by
the instrument. The SCPI names should be used if compatibility is an important consid-
eration.
An overview of the various names is given in table 7-2.
TRIGger Subsystem
To Next Page
Loading...
