Rohde & Schwarz SMB100A - [: S Ource<Hw>]: L IST: D Exchange: a File: S Elect; [: S Ource<Hw>]: L IST: D Exchange: a File: S Eparator: C Olumn

Remote Control Commands
R&S
®
SMB100A
324Operating Manual 1407.0806.32 ─ 13
Example:
MMEM:CDIR '/var/user/listmode/import'
selects the directory for the ASCII files with frequency and level
value pairs.
LIST:DEXC:AFIL:EXT TXT
selects that ASCII files with extension *.txt are listed.
LIST:DEXC:AFIL:CAT?
queries the available files with extension *.txt.
Response: 'list1,list2'
the ASCII files list1.txt and list2.txt are available.
Manual operation: See "Extension - List Mode" on page 165
[:
SOURce<hw>]:LIST:DEXChange:AFILe:SELect <Filename>
The command selects the ASCII file to be imported or exported.
The ASCII files are stored with the fixed file extensions *.txt or *.csv in a directory of
the user's choice. The directory applicable to the commands is defined with the command
MMEMory:CDIR. A path can also be specified in command
SOUR:LIST:DEXC:AFIL:SEL, in which case the files are stored or loaded in the speci-
fied directory.
Parameters:
<Filename> <ascii_file_name>
Example:
LIST:DEXC:MODE IMP
selects that ASCII files with frequency and level value pairs are
imported and transferred into list mode lists.
LIST:DEXC:AFIL:SEL '/var/user/import/list.csv'
selects that ASCII file list.csv is imported.
LIST:DEXC:SEL '/var/user/import/list_imp'
selects that the ASCII file list.csv is imported into list mode list
list_imp.
Manual operation: See "Select ASCII Source / Destination - List Mode"
on page 166
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:COLumn <Column>
The command selects the separator between the frequency and level column of the ASCII
table.
Parameters:
<Column> TABulator | SEMicolon | COMMa | SPACe
*RST: COMMa
SOURce Subsystem