Instrument Function
R&S
®
SMB100A
123Operating Manual 1407.0806.32 ─ 13
5.3.5.2 RF Level Dialog
To open the "RF Level / EMF" dialog, select "RF" > "Configure" > "Level / Attenuator" or
use the MENU key under "RF".
The combined "RF Level / EMF" dialog is divided into the several sections.
The top sections of this dialog provide access to the level settings.
The offset-free level, level offset and level limit are set in the top section of the menu. The
attenuator mode is set in the "Attenuator Settings" section.
The step width which is used when setting the level using the rotary knob (with "Variation
Active On") is set in the "User Variation" section.
The power-on behavior of the instrument and the level display in the display header are
set in the "Power-On / EMF Settings" section (see chapter 5.3.5.3, "Power-On/EMF Set-
tings", on page 127).
Level Settings
The offset-free level, attenuation mode, level offset and level limit are set in the top section
of the menu.
If you have the instrument equipped with a harmonic filter, (options R&S SMB-B25/-B26),
you can also configure the filter.
RF Block
To Next Page
Loading...
