Rohde & Schwarz SMB100A - Date and Time; Network Settings

Instrument Function
R&S
®
SMB100A
90Operating Manual 1407.0806.32 ─ 13
5.2.3.10 Date and Time
The "Date/Time..." dialog provides access to the system time and date settings. It is
opened using the SETUP or MENU key under "Environment". The time is used on the
internal controller.
To prevent accidental changes, "Date" and "Time" are protected functions. They can be
accessed with protection level 1, see chapter 5.2.3.14, "Protection", on page 96.
Date
Indicates the date in the format day.month.year.
In order to prevent accidental changes, this parameter is protected. It can be accessed
with protection level 1, chapter 5.2.3.14, "Protection", on page 96.
Remote command:
:SYSTem:DATE on page 403
Time
Indicates the time in the format hour.minute.second
In order to prevent accidental changes, this parameter is protected. It can be accessed
with protection level 1, see chapter 5.2.3.14, "Protection", on page 96.
Remote command:
:SYSTem:TIME on page 403
5.2.3.11 Network Settings
The "Network Settings" dialog provides access to the network settings. To access this
dialog, press the SETUP or MENU key under "Environment". The R&S SMB is equipped
with a network interface and can be connected to an Ethernet LAN (local area network).
How to connect the signal generator to the network is described in chapter 2.6.1, "Con-
necting the Instrument to the Network", on page 34.
Risk of network errors!
Connection errors can affect the entire network.
If your network does not support DHCP, or if you choose to disable dynamic TCP/IP
configuration, you must assign valid address information before connecting the instru-
ment to the LAN.
Contact your network administrator to obtain a valid IP address.
General Instrument Settings