Instrument Function
R&S
®
SMB100A
83Operating Manual 1407.0806.32 ─ 13
By default the instrument uses correction data obtained in the factory before delivery. In
addition, customer data can be used for external level correction. The customer data is
obtained using a R&S NRP power sensor. External level correction is a protected function
(see Service Manual, chapter 2, "Adjustment").
Remote command:
:CALibration<hw>:LEVel:EXTern:DATA on page 251
Adjust Stereo Coder
Performs all adjustments which affect the analog channels of the stereo coder. For the
adjustment of the S/P DIF see Service Manual, chapter 2, "Adjustment".
Remote command:
[:SOURce]:CALibration:STEReo:ANALog[:MEAS]? on page 252
5.2.3.2 Hardware Config
In the "Hardware Config" dialog, the installed assemblies together with their variants and
revision states can be displayed for servicing purposes.
To open the "Hardware Config" dialog, select "System" and press the SETUP or
MENU key.
Section "Counter" in the upper part of the menu shows the "Operation Time" (in hours)
and the number of power-on ("Power On Counter").
The second part of the menu is a table that lists the installed assemblies. It is divided into
the sections:
●
"Common Assembly"
●
"RF Assembly"
●
"Baseband Assembly"
Operation Time / h
Displays the operation time in hours.
Remote command:
:DIAGnostic:INFO:OTIMe? on page 253
General Instrument Settings
To Next Page
Loading...
