Rohde & Schwarz SMB100A - System:mmemory:path:user; TEST Subsystem

Remote Control Commands
R&S
®
SMB100A
404Operating Manual 1407.0806.32 ─ 13
Example:
:SYSTem:OSYStem?
Response: "Linux"
Usage: Query only
:SYSTem:MMEMory:PATH:USER?
Queries the mass memory path of the user directory.
Return values:
<PathUser> string
Example:
:SYSTem:MMEMory:PATH:USER?
Response: "/var"
Usage: Query only
7.15
TEST Subsystem
The TEST system contains the commands for performing the routines as well as for direct
manipulation of the hardware assemblies (:TEST:DIRect).
The self tests return a "0" if the test is performed successfully, otherwise a value other
than "0" is returned. None of the commands of this system have an *RST value.
Improper use may destroy the assembly!
The respective hardware assembly responds directly to the :TEST:DIRect command;
any safety mechanisms are bypassed. The command is used for servicing purposes and
should not be applied by the user.
:TEST<hw>:ALL:STARt..................................................................................................404
:TEST<hw>:ALL:RESult?................................................................................................405
:TEST<hw>:DIRect........................................................................................................405
:TEST<hw>:ALL:STARt
This command performs a selftest on all installed hardware options. The selftest result
is queried with the command :TEST<hw>:ALL:RESult? on page 405.
Example:
TEST:ALL:STAR
Starts the selftest
Usage: Event
Manual operation: See "Selftest" on page 89
TEST Subsystem