Remote Control Commands
R&S
®
SMB100A
432Operating Manual 1407.0806.32 ─ 13
This flag signals whether traffic information is currently being broadcast.
Use the SCPI command [:SOURce]:STEReo:RDS:TRAFfic:ANNouncement[:
STATe] instead.
Setting parameters:
<State> 0 | 1
Example:
STEReo:DIRect "TA=1"
The traffic announcement flag is set to "1".
Example:
STEReo:DIRect? "TA"
Response: "1"
STEReo:DIRect "TP=<State>"
STEReo:DIRect? "TP"
(for documentation reasons only)
Sets or reads the traffic program flag. This flag signals whether traffic information is gen-
erally transmitted.
Use the SCPI command [:SOURce]:STEReo:RDS:TRAFfic:ANNouncement[:
STATe] instead.
Setting parameters:
<State> 0 | 1
Example:
STEReo:DIRect "TP=1"
The traffic program flag is set to "1".
Example:
STEReo:DIRect? "TP"
Response: "1"
STEReo:DIRect "TRANS<DataNumber>=<DataStream>"
STEReo:DIRect? "TRANS<DataNumber>"
Transparent mode.
An RDS data stream of binary data is generated. If transparent data is selected, all other
RDS data is ignored.
Parameters:
<DataNumber> Max. 20 different data sequences can be defined.
Range: 0 to 13
<DataStream> 16 ASCII coded hexadecimal characters (blocks A to D of the RDS
groups)
TRANS=0 deletes all transparent data and switches back to nor-
mal RDS data transmission.
Note: 16 characters must be specified for each data sequence.
Leading zeros, if any, must also be specified. The data will be
transmitted even if it constitutes no meaningful RDS data.
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
To Next Page
Loading...
