Instrument Function
R&S
®
SMB100A
152Operating Manual 1407.0806.32 ─ 13
Start Freq - Frequency Sweep
Sets the start frequency.
Remote command:
[:SOURce<hw>]:FREQuency:STARt on page 307
Stop Freq - Frequency Sweep
Sets the stop frequency.
Remote command:
[:SOURce<hw>]:FREQuency:STOP on page 308
Center Freq - Frequency Sweep
Sets the center frequency.
Remote command:
[:SOURce<hw>]:FREQuency:CENTer on page 303
Span - Frequency Sweep
Sets the span.
Remote command:
[:SOURce<hw>]:FREQuency:SPAN on page 307
Current Freq - Frequency Sweep
Displays the current frequency.
If "Step" is set, the frequency for the next frequency step of the sweep is entered here.
Remote command:
[:SOURce<hw>]:FREQuency:MANual on page 305
Spacing - Frequency Sweep
Selects linear or logarithmic sweep spacing.
"Linear"
With the linear sweep, the step width is a fixed frequency value which
is added to the current frequency. The step width is entered below.
"Logarithmic"
With the logarithmic sweep, the step width is a constant fraction of the
current frequency. This fraction is added to the current frequency. The
logarithmic step width is entered below in %.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing on page 382
Shape - RF Frequency Sweep
Selects the cycle mode for a sweep sequence (shape).
RF Block
To Next Page
Loading...
