Rohde & Schwarz SMB100A - Page 291

Remote Control Commands
R&S
®
SMB100A
275Operating Manual 1407.0806.32 ─ 13
:OUTPut<hw>:AFIXed:RANGe:LOWer?...........................................................................275
:OUTPut<hw>:AFIXed:RANGe:UPPer?............................................................................275
:OUTPut<hw>:ALC:SEARch:MODE.................................................................................276
:OUTPut<hw>:AMODe...................................................................................................276
:OUTPut<hw>:FILTer:AUTO...........................................................................................276
:OUTPut<hw>:FILTer[:LPASs]:STATe..............................................................................276
:OUTPut<hw>:IMPedance?.............................................................................................277
:OUTPut<hw>:PROTection:CLEar...................................................................................277
:OUTPut<hw>:PROTection:TRIPped?..............................................................................277
:OUTPut<hw>[:STATe]...................................................................................................278
:OUTPut<hw>[:STATe]:PON...........................................................................................278
:OUTPut<hw>:AFIXed:RANGe:LOWer?
The command queries the minimum level which can be set without the attenuator being
adjusted (Attenuator FIXed).
Return values:
<Lower> float
Increment: 0.01
Default unit: dBm
Example:
OUTP:AFIX:RANG:LOW
queries the minimum level for the FIXed setting.
Example:
Response: -50
The minimum level is -50 dBm.
Usage: Query only
Manual operation: See "Fixed Range (PEP) In" on page 126
:OUTPut<hw>:AFIXed:RANGe:UPPer?
The command queries the maximum level which can be set without the attenuator being
adjusted (Attenuator FIXed).
Return values:
<Upper> float
Increment: 0.01
Default unit: dBm
Example:
OUTP:AFIX:RANG:UPP
queries the maximum level for the FIXed setting for the RF output.
Example:
Response: -27
The maximum level is -27 dBm.
Usage: Query only
Manual operation: See "Fixed Range (PEP) In" on page 126
OUTPut Subsystem