Instrument Function
R&S
®
SMB100A
110Operating Manual 1407.0806.32 ─ 13
Recent data sets
Displays the files last used. The entire path is shown.
If the desired file is in the list, it can be selected.
Remote command:
n.a.
Directory
Enter the directory in which the file with the instrument setting to be loaded is located.
The "Selected file" window lists all the files in this directory.
Remote command:
:MMEMory:CDIRectory on page 270
File List
Selects the file with the desired instrument configuration.
Remote command:
:MMEMory:CATalog? on page 269
Exclude Frequency
The current frequency is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]:RCL on page 304
Exclude Level
The current level is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL on page 342
Recall
Load the selected configuration.
If an instrument setting in which a sweep was activated is stored, the sweep is started
when the recall command is called.
If an instrument setting which accesses lists is stored, this list is also loaded.
General Instrument Settings
To Next Page
Loading...
