Instrument Function
R&S
®
SMB100A
196Operating Manual 1407.0806.32 ─ 13
Pulse Period - Pulse Generator
Sets the period of the generated pulse. The period determines the repetition frequency
of the internal signal.
Remote command:
[:SOURce<hw>]:PULM:PERiod on page 352
Pulse Width - Pulse Generator
Sets the width of the generated pulse. The width determines the pulse length. The pulse
width must be at least 20 ns less than the set pulse period.
Remote command:
[:SOURce<hw>]:PULM:WIDTh on page 364
Pulse Delay - Pulse Generator
(External trigger only)
Sets the pulse delay. The pulse delay determines the time that elapses after a trigger
event before pulse modulation starts. The pulse delay is not effective for double pulse
generation.
Remote command:
[:SOURce<hw>]:PULM:DELay on page 350
Double Pulse Width - Pulse Generator
(Double Pulse only)
Sets the width of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:WIDTh on page 351
Double Pulse Delay - Pulse Generator
(Double Pulse only)
Sets the delay from the start of the first pulse to the start of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:DELay on page 351
Trigger Mode - Pulse Generator
Selects the trigger mode for pulse modulation.
Note: An external trigger signal is supplied via the PULSE EXT connector.
"Auto"
The pulse generator signal is generated continuously.
"Extern Single"
The pulse modulation is triggered by an external trigger event.
"Extern Gated"
The pulse generator signal is gated by an external gate signal.
Remote command:
[:SOURce<hw>]:PULM:TRIGger:MODE on page 359
Execute Single Trigger
Triggers the pulse signal manually.
Modulation Generator and LF Output
To Next Page
Loading...
