Remote Control Basics
R&S
®
SMB100A
213Operating Manual 1407.0806.32 ─ 13
To enable the external controller to communicate with the software via TCP/IP protocol,
set up a remote control link as follow:
1. Connect the controller and the instrument to the network (network cable) and switch
them on.
2. Start the 'Measurement & Automation Control' program on the controller.
3. Select "Devices and Interfaces > Create New".
4. Select "VISA TCP/IP Resource" and confirm with "Next".
5. Choose the type of TCP/IP resource you wish to add and select Next.
6. Enter the IP address or the host name of the R&S SMB and select "Next".
Starting a Remote Control Session
To Next Page
Loading...
