Remote Control Commands
R&S
®
SMB100A
420Operating Manual 1407.0806.32 ─ 13
Setting parameters:
<PS> 8 ASCII characters
Note: An eight-digit value must always be set. Blank spaces, if
any, must also be entered, otherwise the value will not be accep-
ted.
Example:
STEReo:DIRect "EON-PS=1000,Test 123"
Sets the program service name for the EON with PI=1000 to "Test
123".
Example:
STEReo:DIRect? "EON-PS,1000"
Reads the program service name of the EON with PI=1000.
Response: "Test 123"
STEReo:
DIRect "EON-PTY=<PI>,<PTY>"
STEReo:DIRect? "EON-PTY,<PI>"
Enhanced Other Networks: sets the program type (PTY) for the EON with the selected
<PI>.
Parameters:
<PI> Range: 0000 to FFFF (ASCII coded hexadecimal numbers)
Setting parameters:
<PTY> Range: 00 to 31 (ASCII coded decimal numbers)
Example:
STEReo:DIRect "EON-PTY=1000,10"
Sets the program type for the EON with PI=1000 to "10".
Example:
STEReo:DIRect? "EON-PTY,1000"
Reads the program type of the EON with PI=1000.
Response: "10"
STEReo:DIRect "EON-TA=<PI>,<TA>"
STEReo:DIRect? "EON-TA,<PI>"
Enhanced Other Networks: sets the TA flag for the EON with the selected <PI>.
Parameters:
<PI> Range: 0000 to FFFF (ASCII coded hexadecimal numbers)
Setting parameters:
<TA> 0 | 1
Example:
STEReo:DIRect "EON-TA=1000,1"
Sets the TA flag for the EON with PI=1000 to "1".
Example:
STEReo:DIRect? "EON-TA,1000"
Reads the TA flag of the EON with PI=1000.
Response: "1"
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
To Next Page
Loading...
