Setup
A4-30 ENVI-MAG Manual
(+- ESC) LCD Intensity
(1) Data Output
(2) Factory Test #
(3) Lock OFF
(4) Reprogram System
Select function
2. Make sure the baud rate under Data Output is set at 9600.
3. Press the “4” key to start the procedure.
4. You will now see a warning and confirmation screen as follows:
5. Press the “Y” key to continue.
6. At this point the PC will start to display the activity of the download
procedure showing the percentage that is complete.
7. When the download is finished, i.e. 100% complete on the PC, wait for
about 10 to 15 seconds for the ENVI-MAG to reprogram. The ENVI-MAG
will then automatically perform a cold boot and you are ready to
survey.
auxiliary functions
4
! ! ! WARNING ! ! !
You are about to REPROGRAM your current
version of the operating system. This
process will also destroy all of your
stored data if any.
Do you want to proceed ? (Y/N)
9
To Next Page
Loading...