Repacking
ENVI-MAG Manual A2-3
Preparation
Repacking
Repacking should follow the above order in reverse, that is, start with layer 7
(or 8 depending on your options) and proceed upwards. Please make certain
that the batteries are removed and stored in the appropriate places on layer 4.
Failing to do so may result in damaged batteries and possibly a damaged console.
Warning: The batteries must be removed from the unit prior to shipping or storage.
FAILURE TO DO SO MAY RESULT IN DAMAGE.
Assembly
In order to make the system as compact as possible for shipment and storage, and
considering the various sensor configurations available, the ENVI-MAG system
requires you to connect up the external components. This section will describe
the steps required to completely assemble your instrument.
Connecting the sensor(s) to the cable
The sensors are located in layer 6 of the packing materials, while the cables are
located in layer 4.
The following illustrations show the proper cable connections for each of the
different sensor configurations. The sensors are shown being viewed from their
bottoms looking at the screw terminals.
5
¾ inch (12.5mm)
slab
Slab can be cut to obtain:
2 Cushions for Back Plate
2 Cushions for Strap
6
3 inch (75mm) slab Total Field Sensor
Gradiometer Sensor
Heavy Duty Battery
Charger
7
1inch (25mm) slab Full slab at bottom
8*
3 inch (75mm) slab Optionally, another layer containing the
Base Station Cable or the Heavy Duty
Battery Pack
Layer Description Contains
To Next Page
Loading...
Need help?
General