NVI-MAG
ENVI-MAG Manual A3-1
Chapter
Instrument
3
The Instrument
This chapter is about the instrument itself and fully describes:
▲ the ENVI-MAG console,
▲ the keypad functions,
▲ the various display menus,
▲ the display formats that you will encounter.
Pre-defined operating modes
To make the ENVI-MAG easier to use, it has a menu of seven pre-defined
configurations, in three modes, to choose from. The menu is obtained by
pressing the “SETUP + ON” keys simultaneously.
Basic mode
▲ used for site characterization, drum location and archaeology
▲ operates in the WALKMAG mode (continuous reading)
▲ does not have on-line data recall features; you have to dump the data to a
computer to inspect it—you can still see a graphical display of the data
▲ data correction is from a base-station or the TIE-PT Loop mode only
Search mode
▲ operates in a continuous reading mode, but the data is not stored in memory
▲ you can see a graphical display of the data as it is collected
Advanced mode
▲ used for ground water, mineral, oil and gas exploration or detailed site
characterization, drum location, archaeology, etc.
▲ allows you to adjust all possible parameters of the ENVI-MAG
To Next Page
Loading...
Need help?
General