Output
A6-10 ENVI-MAG Manual
Dumping data
Data can be dumped in three different ways:
▲ all data—regardless of method; one big sequential dump,
▲ by method or sub-method, i.e. total-field, gradient or base,
▲ on a line by line basis.
All data
At the START output of: display proceed as shown:
START of:
BY LN: yn
: all data recorded LN:llll.l d
MAG: t-fld grad. base
BAUD:bbbbb
DL: tttBIT:b
FMT:xxxxx
Output: START BATT: bbb
1. Press the “NEXT” key until the cursor rests within the left sub-page.
2. Move the cursor to: all data recorded
3. Press the “START” key.
Options: Press the “STOP” key to temporarily suspend dumping.
Press the “ESCAPE” key to abort the dump.
locationsoutput
To Next Page
Loading...