Output
A6-12 ENVI-MAG Manual
Line by line
At the START output of: display proceed as shown:
START of:
BY LN: yn
: all data recorded LN:llll.l d
MAG: t-fld grad. base
BAUD:bbbbb
DL: tttBIT:b
FMT:xxxxx
Output: START BATT: bbb
1. Press the “NEXT” key until the cursor rests within the top right sub-page,
i.e. the locations block.
2. Move the cursor to BY LINE:
3. Select! YES to activate this function.
4. Move the cursor to LN:
5. Enter! the desired Line number and direction.
6. Press the “NEXT” key until the cursor rests within the left sub-page.
7. Move the cursor to one of: MAG: T-FLD GRAD. BASE
8. Press the “START” key.
Options: Press the “STOP” key to temporarily suspend dumping.
Press the “ESCAPE” key to abort the dump.
9. Repeat steps 4 to 8 as required.
10. Press the “ESCAPE” key to return to the Main operating display.
locationsoutput
To Next Page
Loading...