NVI-MAG
ENVI-MAG Manual A4-1
Chapter
Setup
4
Setting-up the ENVI-MAG
This chapter describes the process of how to:
â–² initialize the ENVI for first time operation,
â–² program it for the different modes of operation,
â–² enter line and station numbers.
Step by step procedures are given in Chapter 5 on how to perform:
â–² a total-field survey in the WALKMAG mode (basic)
â–² a gradiometer survey in the stop-and-go mode (advanced)
â–² base-station operation (advanced)
First time operation
A special procedure has to be followed to get the ENVI-MAG software set up
properly. This procedure is called a cold boot. This assures that all setup
parameters are initialized properly and that the memory is cleared.
Important:First time operation procedures (cold boot) have to be carried out
every time the instrument has had its battery disconnected for more
than 10 minutes. You may also need to cold boot if the screen stays
blank or is scrambled.
To Next Page
Loading...
Need help?
General