Setup
A4-12 ENVI-MAG Manual
ADVANCED MODE
The ENVI-MAG setup in the advanced mode, initializes parameters which are
common to all three of the exploration (ground water, mineral, and oil & gas)
configurations installed. This mode gives you total control over all the parameters
of the ENVI-MAG. You can also use this mode to run the types of surveys defined
in the Basic mode, with the additional benefit of more features being available.
Several examples will be given to show you how to setup:
▲ the instrument operating details (how long and how often a reading is taken)
▲ a total-field WALKMAG and/or WALKGRAD survey
▲ a gradiometer Stop-and-Go survey
▲ a base-station operation
▲ note entry
▲ other auxiliary functions
Instrument setup
The following setup prepares the instrument for a total-field or gradient survey in
the WALKMAG or WALKGRAD modes respectively. This mode uses the cycle re-
peat feature of the measurement. A cycle delay can also be entered, so that the
repetition rate is adjusted while walking uphill or downhill.
From the Main operating display proceed as follows:
1. Press the “SETUP” key.
The INSTRUMENT SETUP display appears:
MAG SETUP: ->menu AUTO ST.INC.: yn
LINK REC/START: yn
CYCLE REPEAT: yn
CYCLE DELAY: yn
ERASE MEMORY: yn
HEATER: yn
Chg?:ENT. BATT:bbb
5
instrument setup
To Next Page
Loading...
Need help?
General