ENVIMAP Installation
C2-14 ENVI-MAG Manual
Manual installation
If you get an installation problem that you cannot solve, you can try to install the
system without using
INSTALL.BAT by following these steps.
1. Ensure you have sufficient free disk space available (about 2.4 Mb
for this system).
2. Create an installation directory and make it the default. For example:
MD \ENVIMAP
CD \ENVIMAP
3. Enter: SET ENVIMAP=C:\ENVIMAP
where C:\ENVIMAP is assumed to be the directory in which
you wish to install ENVIMAP.
4. Copy the file PKUNZIP.EXE from the INSTALLATION DISK.
5. Enter: PKUNZIP A:\1000
This will expand the installation files into the \ENVIMAP directory
(assuming that the source disk drive is
A:).
6. Enter: ENVIMAP to start the program.
7. Select the SYSTEM CONFIGURATION menu.
8. Configure your system by selecting appropriate configuration options.
9. Edit your AUTOEXEC.BAT and CONFIG.SYS files and make sure they
include the necessary components described in section 2.
10. Re-boot your computer, checking for errors.
To Next Page
Loading...