Instrument
A3-38 ENVI-MAG Manual
Data output display
This display allows the selection of:
â–² communication parameters between the ENVI-MAG and the output device
such as a computer or printer,
â–² the data format of the output,
â–² and possibly the Line number, if a line by line data dump is desired.
Data can be dumped in its entirety at once, or selectively on a mode basis.
This display is accessible from the Auxiliary display.
START of:
BY LN: yn
: all data recorded LN:llll.l d
MAG: t-fld grad. base
BAUD:bbbbb
DL: tttBIT:b
FMT:xxxxx
Output: START BATT: bbb
Figure A-32 The data output display.
Parameter Description Default
: all
data
recorded
With the cursor placed after the colon, all the
data in the instrument would be dumped
sequentially into one, possibly very large file.
MAG
Lists the modes available for the ENVI-MAG.
As shown, only the gradiometer data would be
dumped as indicated by the cursor position
BY LN
yes/no
Directs the instrument to dump the data on a
line by line basis, in addition to a method by
method basis.
This is usually left at no.
no
locationsoutput
To Next Page
Loading...
Need help?
General