Operating displays
ENVI-MAG Manual A3-39
Instrument
LN
The line number whose data has to be dumped,
consisting of the numeric and directional
parts.
BAUD
The Baud rate of communication with the
output device.
The following choices are available by scrolling:
600, 1200, 2400, 4800, 9600, 19200,
38400, 57600 Baud.
9600
DL
A delay which may be added after each carriage
return/linefeed (CR/LF) to accommodate slow
peripherals such as some printers.
The range is 0 to 999 ms.
This value is normally left at 0 for dump to
computers.
The proper setting has to be established
experimentally for other equipment. Problems
usually are indicated by the loss of a few
characters.
0
BIT
The number of data bits.
The default value is 8 bits, which usually works
properly.
The proper setting has to be established
experimentally. For example, on some EPSON
printers, 7 or 8 bits results in either normal
or italic print.
8
FMT
The output data format.
The formats are described briefly in the following
table on page A3-40.
Parameter Description Default
To Next Page
Loading...
Need help?
General