If you have problems
ENVI-MAG Manual C2-13
Installation
If you have problems
This section describes some of the problems that may be encountered, along
with a description of what the INSTALL procedure does to your system. Under
most circumstances, you shouldn’t have to refer to this section.
What INSTALL does
The installation procedure is controlled by a batch files named INSTALL.BAT. It
does the following tasks:
1. Sets the default directory to the destination \ENVIMAP directory, creating it
if necessary. It also checks if the correct syntax was used for the
INSTALL
command, displaying an error message if it was not.
2. Copies the expansion program PKUNZIP.EXE from the INSTALLATION
DISK to the ENVIMAP directory.
3. Expands needed installation files from the INSTALLATION DISK.
4. Checks if the system is being installed over an existing ENVIMAP installation
by comparing the destination directory with the existing
ENVIMAP
environment variable.
If the installation is to a new directory, the AUTOEXEC.BAT and CONFIG.SYS
files on drive
C: are modified, the ENVIMAP environment variable is set, and
the ENVIMAP directory is added to the beginning of the system PATH.
5. You are prompted for your name, your company name and the city in
which the licensed computers are located. This registration information is
recorded on the INSTALLATION DISK and on your computer.
6. If any errors occurred during INSTALL, an error message is displayed
showing the
INSTALL command that you entered, and an explanation of
the correct syntax.
7. ENVIMAP is run with the SYSTEM CONFIGURATION menu to allow you to
configure the ENVIMAP System to your computer capabilities.
8. You are asked to re-boot the computer.
The installation procedure is now complete.
You should now be able to start working with the ENVIMAP System. If you have
encountered any problems, please refer to the following installation notes.
To Next Page
Loading...
Need help?
General