Setup
A4-8 ENVI-MAG Manual
Entering the starting station
2. Move the cursor to ST:
3. Enter! 50.
4. Move the cursor one step forward.
5. Enter!
n (for north).
6. Move the cursor to
SEP:
7. Enter! -
10. Note: The ‘-’ causes the station number to decrement. This
indicates that you will be travelling south and that stations are spaced
10 units apart).
Entering the starting line
8. Move the cursor to LN:
9. Enter!
16
10. Move the cursor one step forward.
11. Enter!
e (for east)
12. Move the cursor to
SEP:
13. Enter!
2 (This indicates that you will be surveying successive lines 2
units apart and you will be moving in a easterly direction.)
To set your required starting point and separations, just substitute your specific values
in the previous steps. Also, keep in mind that entering negative values for the
separation parameters causes the respective line or station values to decrement.
3
50
3
5
3
-10
3
16
3
2
3
2
To Next Page
Loading...
Need help?
General